How to dismantle and reassemble your dryer for internal cleaning

Standard

Looking to clean the inside of your clothing dryer machine?  Follow these steps to safely access the inside of your drying machine.

Step 1:  Turn off any source of power to your dryer.  This could be simply unplugging the machine from the wall, or turning off the gas supply if that is how your dryer gets its power.

Step 2: Remove the lint screen and screws at the top of the lint screen (you will need a screwdriver to do this).  Remember, do not continue use of a damaged lint screen as this could be hazardous to your dryer.

lint screws

Step 3: Release the clips that hold the top of the machine to the front frame of the dryer.  To do this you will need a putty knife to push into the space between the top and the frame of the machine.  The release clips are about an inch in from the right and left sides of the machine.  This will release the top of the machine from the frame.  Make sure that the top of the machine is able to lean up against a wall so that the wires that connect it don’t strain.

putty knife

Step 4: Release the door switch. (You will need a screwdriver to do this)

door switch

Step 5: Unscrew the nuts on the inside of the front frame so that you will be able to remove the front frame from the machine completely.

unscrew nuts

Step 6: Lift up on the front panel of the machine, so that it unhooks from the bottom.  You should now be able to move the front dryer panel to the side.  Do not be alarmed if the drum begins to lean forward a little bit.  This will be put back into place while reassembling your dryer.

Step 7: Using a vacuum tool attachment, you should be able to reach all of the dust collecting crevices your drying machine might have.

vacuum inside of dryer

*Once you have cleaned the inside of your drying machine, you are now ready to reassemble your dryer.

Step 8: There should be holes at the inside bottom of your front panel.  These will allow the hooks at the bottom of the machine to slide back into place.  Here is where you would push the drum back into place if it had previously shifted.

Step 9: Re-screw the nuts into the inside wall of the machine to connect the front panel and the body of the machine.

Step 10: Reconnect the door switch and close the lid.  Push down to lock the top lid into place.

Step 11: Re-screw the lint screen screws and replace the lint screen.

Happy cleaning!


*WARNING: Before starting any repair, always make sure that the appliance is completely disconnected from the power source by unplugging it.  This tutorial is meant to be a guide and should not be used in place of the installation instructions provided by the manufacturer.  

If you have any questions, comments or concerns, feel free to leave a reply at the bottom of this post!

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.