Why is my dryer spinning but not producing any heat?


There could be many reasons as to why your dryer is still spinning but not producing any heat. Your dryer consists of so many different parts that any one could contribute to this problem. Listed below, we have the most likely parts that could be causing this problem. First, see if these parts are the issue, if not you may need technical help from a repair guide.

Continue reading

Product pick of the week: Thermal Fuse


Welcome to our new series, every week we will be selecting a new part or product we sell and explaining its use and importance. This article will talk about Thermal fuses which are used for your drying machine. If your dryer is not heating it may be a faulty thermal. 1st Source Servall will explain how this part works and why it is important.

A thermal fuse is a safety part that’s purpose is to shut off the electrical flow that powers the heating mechanism when the exhaust becomes overheated. It is similar to an electrical fuse and it can’t be reset, it must be removed and replaced when it is worn out or broken.

Continue reading

Product Pick of the Week: Dryer Timers


Dryers: we’re all pretty familiar with them.  For decades, they’ve helped to make laundry a little bit easier, saving us the hassle of having to line dry everything and speeding things up so we can have our warm fluffy towels, dry clothes, blankets, and more sooner.

We turn the knob, push start and expect it to handle the rest.  But how does the dryer know just what to do?  Part of this is thanks to the Dryer Timer, a key player when it comes to managing the different cycles, which is why they’re this week’s Product Pick. Continue reading

Why Isn’t My Dryer Heating Up? 5 Areas To Check on Your Dryer.


If your dryer isn’t heating up like it used to, there are 5 areas to check.

  1. Proper Voltage
  2. Heating Element
  3. Thermal Fuse
  4. Thermostat
  5. Timer Motor

Proper Voltage: There are three ways to see if the proper amount of power is making it to your dryer.

(1) Making sure the dryer is properly plugged in.
(2) Check the circuit breaker to see if all the breakers are correct.
(3) Check for fuses in your fuse panel.

Heating Element: Once your heating element breaks, it is not fixable and will need to be replaced. It is possible to test your heating element by setting your multi-meter to the Rx1 resistance scale. Take each probe and place it at the end of the element.  If the results come back with infinite resistance, you will need to replace your heating element.

Thermal Fuse: Like the heating element, the thermal fuse is not repairable and will need to be replaced if it is broken. You will have to test the thermal fuse to see if it is working properly. To test the fuse, remove the wires that are leading to the thermal fuse. Take your multi-meter again and set it to the Rx1 setting. For best results, test the thermal fuse at room temperature, resulting in a reading of zero. If you test the thermal fuse when it is heated, a reading of infinity will be produced.

Thermostat: Dryers contain many thermostats to help control the internal temperature. Dryer thermostats are about an inch and a half long, oval shaped, and are connected to two wires. Remove these wires and use your multi-meter to test the thermostats. There should be results of either zero or infinity. If you do not receive either of these results, you need to replace the component.

Timer Motor: The dryer’s timer motor regulates the length of time that power is directed at each component. To find the motor, find the timer assembly. They are located behind the control console panel. Remove the wires from the motor. Set the ohmmeter to the Rx1 setting. A proper reading for dryers falls in the 2000 to 3000 ohms range. A proper reading can be found in the dryer’s owner manual.